China Auto Diagnostic Tools, OBD2 Scanner Wholesale Center

car key programmer
Home >  News & Notices >  Vertical 368A Key Cutting Duplicated Machine operation instructi

Knowledgebase

Search your questions?


Vertical 368A Key Cutting Duplicated Machine operation instructi

                                               Vertical 368A Key Cutting Duplicated Machine operation instruction


368A key duplicator with horizontal feeding movable handle is obddiagnosticcenter.com newest key cutting machine. Vertical 368A Key cutting machine working power is 200W, can use to copy various hollowness type,wave type,cylindrical key and key for multi lock and composite bead keys and some car keys.

Vertical 368A key cutter 200W 368A key cutting duplicated machine 368A Auto key copier

368A key cutting machine 368A key cutter
Copy of dual bead key For copy the MUL-T-LOCK key, you must use two different sets of cutter and needle. Below, I will sharing the copy method is as follows:
1) First take V type of drill and spring needle into the pivot hole respectively. ( Guide needle must be than the cutter out of about 7mm)

2) Two key blanks are clamped with clamp respectively, then slowly pass down vertical feed handle, make axis of spring and needle inside the machine itself be spring compression to guide tip in contact with the key billet surface, vertical depth adjusting knob, then turn needle up, cutting tool dropped to the point contact until key blank plane; put the handle reset, then lock up depth of the fixed button. At this point can be replicated in hole drilling, after copying the side, clamp the reverse of key blank, copy the complete order. (when you need to copy the opposite, only clamp the reverse of key blank and do not unload the original keys)

3)To unload V type of cutter and guide needle, loaded on W type of cutter and guide needle (guide needle must be thank the cutter out of about 5mm) ress the handle. Make needle touches the surface of key, then turn vertical depth adjusting knob to make the surface of cutter also touches the surface of key, reset vertical feed handle, lock vertical depth fixed button, the outside hole can be copied at this time. According to the order clamp the reverse of key blank to drill keys, copying the work is done.


VXDAS VX09